whm on a xenserver behind NAT

samuel wang

• March 26, 2015 02:05

Hello all, I installed whm on a xenserver virtual machine few weeks ago,then I restore the accounts from the existing whm server which is on a public server.the new one just fir backup in case the existsing server crash(if that i only change the domain on whois and nameserver is ok). What should i do? the new server local ip is 10.4.xxx.xxx and public ip is 103.28.xxx.xxx the old server ip is 203.73.xxx.xxx I really dont know how nat ,I try to visit

• 

  cPanelMichael

  • March 26, 2015 16:45

  Hello, Please ensure you review the following document if you are using a NAT environment:

  0
• 

  samuel wang

  • March 30, 2015 07:27

  Thank you for reply. I have read it.some of the route port have been used(for example 80 and 8080). I not sure wether it will affect my other applicaton,so I didn't run the last command /scripts/build_cpnat --man.

  0
• 

  samuel wang

  • March 30, 2015 07:34

  It said that if the installer detects a NAT-configured network, your server will configure itself for NAT mode and attempt to automatically map local IP addresses to public IP addresses.I remebered i didn't detected,but it also auto map it. and dose it mean I no need to do anything?

  0
• 

  cPanelMichael

  • April 06, 2015 19:00

  It said that if the installer detects a NAT-configured network, your server will configure itself for NAT mode and attempt to automatically map local IP addresses to public IP addresses.I remebered i didn't detected,but it also auto map it. and dose it mean I no need to do anything?

  
  Hello, Could you clarify if your websites are operating as expected or if they are failing to load properly? Thank you.

  0

Please sign in to leave a comment.