bigtomjp

  • Total activity 19
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 4

Activity overview

Latest activity by bigtomjp
  • bigtomjp commented,

    Ok it must just be a timing thing and the stars aligning as I have a backup in S3 now. I will try to make sure this is repeatable.

  • bigtomjp created a post,

    Additional Destination backups are not being transported

    I am having an issue where backups are not being transferred to S3. The S3 destination is validated and enabled. The backup log shows that it is being set into TaskQueue for transfer, but the TaskQ...

  • bigtomjp commented,

    Hi, It says "because of the following error: No space left on device at " - have you checked that you have enough space available? ;) That was it. Looks like the backups were not respecting th...

  • bigtomjp created a post,

    Update stuck at 0% for 12 hours

    Ran the usual update process to update to the latest release version. The process stayed at 0% with the only thing in the log being that the last update log was not found. I did a graceful reboot...

  • bigtomjp commented,

    Needed yum install libmemcached-devel. Installed fine after that.

  • bigtomjp commented,

    Is this as simple as specifying a location? Good place to put it?

  • bigtomjp commented,

    memcached shows in the phpinfo. libmemcached.x86_64 is in the list when I run yum list installed.

  • bigtomjp commented,

    @cPanelLauren This is a few lines just above the error: checking whether to enable memcached protocol support... no checking whether to use system FastLZ library... no checking for ZLIB... yes, sh...

  • bigtomjp created a post,

    Memcached

    I am getting an error installing memcached at the last step of the PHP PECL module when configuring. PHP extension is already installed in EA4. ERROR: `/root/tmp/pear/memcached/configure --with-ph...

  • bigtomjp created a post,

    Setup OData with MySQL

    I cannot find any decent info on setting up OData on a Linux server. Seems to be info only for WinServer IIS. Any info on this would be helpful.