Skip to main content

How do I open a port in Imunify360?

Steven Sublett
  • Updated

Question

How do I open a port in the Imunify360 firewall?

Answer

With Imunify360, adding a port is different depending on which mode is enabled.

Imunify360 has two modes:

  • All open, except specified
  • All close, except specified

The port settings change depending on the blocking mode.

(Blocking Mode) All open

Note: This mode blocks a port using this method.

  1. Navigate to "WHM Home / Imunify360 / Firewall / Ports".
  2. Click the "Add" button.
  3. Enter your port, any related comments, and click "Add Port".
(Blocking Mode) All closed

Note: The interface has changed to display port settings instead of individual TCP/UDP lists. This section also has a tab for IPv4 and IPv6, as they are kept separately.

  1. Navigate to "WHM Home / Imunify360 / Firewall / Ports".
  2. Scroll down to the TCP/UDP inbound/outbound settings.
  3. Enter the desired port either in TCP/UDP inbound to allow incoming connections, or in TCP/UDP outbound to allow outgoing connections.

Additional Resources

Imunify360 Docs - ports

How do I allow an IP address for a port with the Imunify360 firewall

Related articles

Comments

0 comments

Article is closed for comments.

%